CDL General Knowledge Practice Test

This 30-question test follows the common national CDL manual content and the federal pass mark of 80 percent. It covers space management, braking, bad weather, air brakes and inspections.

Loading your quiz… This quiz needs JavaScript. If it does not load, use the study guide at the bottom of this page.

What this test covers

  • Following distance and seeing ahead
  • Stopping distance, braking and skids
  • Hydroplaning and slippery roads
  • Air brake basics and inspection
  • Cargo checks and railroad crossings

30 multiple-choice questions, original wording, each with a short explanation. The federal passing standard for each CDL knowledge test is 80%. Your best score is saved on this device only, so you can see progress without creating an account.

Quick tips for this test

  • Use the one-second-per-10-feet rule below 40 mph, and add one second above that speed.
  • At 60 mph a loaded vehicle needs more than the length of a football field to stop.

Keep practicing

Study guide: all questions with answers

Show every question and the correct answer (study mode)
  1. Federal rules say a CDL knowledge test is passed by correctly answering at least what share of the questions?
    Answer: 80 percent
    49 CFR 383.135 requires a driver applicant to correctly answer at least 80 percent of the questions on each knowledge test.
  2. At what BAC is a driver of a commercial motor vehicle considered to be driving under the influence?
    Answer: 0.04 or higher
    The federal limit for drivers operating a vehicle that requires a CDL is 0.04, half the limit for regular drivers.
  3. How far ahead do most good truck drivers look?
    Answer: At least 12 to 15 seconds
    At lower speeds, 12 to 15 seconds is about one block. At highway speeds it is about a quarter mile.
  4. In normal conditions below 40 mph, how much following distance does the rule of thumb suggest for a commercial vehicle?
    Answer: At least 1 second for each 10 feet of vehicle length
    For example, a 40-foot vehicle needs 4 seconds. A 60-foot rig needs 6 seconds.
  5. Above 40 mph, you should add how much to the following distance rule?
    Answer: One extra second
    At speeds over 40 mph, add 1 second to the one-second-per-10-feet rule, for example 7 seconds for a 60-foot rig.
  6. When you double your speed from 20 to 40 mph, the braking distance becomes:
    Answer: Four times longer
    Doubling speed gives four times the impact force and braking distance. Tripling the speed gives nine times.
  7. Hydroplaning can occur at speeds as low as:
    Answer: 30 mph
    Hydroplaning can happen at 30 mph if there is a lot of water, especially with low tire pressure or worn tread.
  8. If your vehicle is hydroplaning, what should you do?
    Answer: Release the accelerator and push in the clutch; do not use the brakes
    Releasing the accelerator and pushing in the clutch slows the vehicle and lets the wheels turn freely.
  9. Compared with a loaded truck, an empty truck usually requires:
    Answer: A longer stopping distance because it has less traction
    Empty vehicles have less traction, and suspension and brakes are designed to work best when loaded.
  10. How far does a vehicle travel in one second at 55 mph while the driver reacts?
    Answer: About 61 feet for the reaction time given in the manual
    With a reaction time of ¾ to 1 second, a vehicle at 55 mph travels about 61 feet before the brakes are applied.
  11. How often must a truck driver inspect cargo securement after the first 50 miles of a trip?
    Answer: Every 150 miles or every three hours, whichever comes first
    Cargo securement must be inspected within the first 50 miles of a trip and every 150 miles or three hours thereafter.
  12. During a pre-trip check of hydraulic brakes, you should:
    Answer: Pump the pedal three times, then apply firm pressure for five seconds; the pedal should not move
    If the pedal moves under firm pressure, there may be a leak or other problem. Get it fixed before driving.
  13. On an air brake system, the air compressor governor typically stops the compressor at about:
    Answer: 125 psi
    The compressor usually starts at about 100 psi and cuts out at around 125 psi.
  14. The low air pressure warning must come on before air pressure drops below:
    Answer: 55 psi
    A visible warning signal is required before tank pressure falls below 55 psi (or half the governor cutout pressure on older vehicles).
  15. Spring brakes on tractors and straight trucks begin to come on at air pressure of about:
    Answer: 20 to 45 psi
    Spring brakes come fully on at around 20 to 45 psi. Do not wait for them to apply. Stop safely when the warning comes on.
  16. At railroad crossings where a stop is required, where should a bus or hazmat vehicle stop?
    Answer: 15 to 50 feet before the nearest rail
    The manual says to stop 15 to 50 feet before the nearest rail where required.
  17. Which two distances make up your total stopping distance, in addition to perception distance?
    Answer: Reaction distance and braking distance
    Total stopping distance is perception distance plus reaction distance plus braking distance.
  18. Which braking method applies the brakes as hard as you can without locking the wheels?
    Answer: Controlled braking
    With controlled braking, keep steering movements very small. If you must make a larger steering change or the wheels lock, release the brakes and re-apply as soon as you can.
  19. Why should you check mirrors regularly while driving a large vehicle?
    Answer: To know where other vehicles are and whether they move into blind spots
    Regular mirror checks help you see traffic and your own vehicle, but mirrors cannot show every blind spot.
  20. What is a good reason to avoid trying to drive faster than the flow of traffic?
    Answer: You will not save much time and will pass more vehicles, increasing crash risk
    Speeding to save time is rarely effective and increases crash risk and fatigue.
  21. When should you do an after-trip inspection and report?
    Answer: At the end of each trip or day
    The after-trip inspection report notes any problems so they can be fixed. It is required at the end of the trip, day or tour of duty.
  22. What does the CDL manual say you should do if you see, hear, smell or feel something that might mean trouble?
    Answer: Check it out
    Investigate immediately, because small problems can become serious failures on the road.
  23. On a slippery road, using a retarder (engine brake) can:
    Answer: Cause the drive wheels to skid
    Retarders act only on the drive wheels. On low-traction surfaces they may cause the wheels to skid, so use caution.
  24. Increasing speed from 20 mph to 60 mph makes braking distance:
    Answer: Nine times longer
    Triple the speed means nine times the braking distance. At 60 mph stopping distance is greater than the length of a football field.
  25. At 60 mph, a loaded commercial vehicle's stopping distance is greater than the length of:
    Answer: A football field
    The manual notes that at 60 mph your stopping distance is greater than the length of a football field.
  26. What should you do regularly with air tanks to remove water and oil?
    Answer: Drain them completely using the drain valves
    Each air tank has a drain valve. Moisture and oil can collect in tanks and should be drained.
  27. The main danger of tailgating in a commercial vehicle is:
    Answer: Not having enough time to react if the vehicle ahead brakes
    Following too closely is a leading cause of rear-end crashes. Keep a safe following distance.
  28. What does a high-speed turn onto a slippery road tend to cause?
    Answer: Skids and loss of traction
    You cannot steer or brake without traction. Slow down before turns on slippery roads.
  29. What is perception distance?
    Answer: The distance you travel from the time your eyes see a hazard until your brain recognizes it
    Perception distance is the first part of total stopping distance, followed by reaction distance and braking distance.
  30. If your brakes fail on a long downgrade, what is usually your best hope?
    Answer: An escape ramp
    Once brakes have failed you need something outside the vehicle to stop it. Escape ramps are signed and usually located a few miles from the top of the downgrade.

Tip: try the quiz first, then use this list to review. Seeing the answers before you practice will not help you remember them on test day.